SUZUKI ENGINE PAGE on TZT3 and GP1871 MFD?

[Jimmy]

Dear Furuno team,

We just installed new Suzuki 2023 DF350F outboard engine and new Suzuki gateway also have TZT3 -16F and GP1871 MFD.

TZT3 -16F software ver.3.56
GP1871 MFD software ver.5.01

I can saw the engine data in databox page,
But can’t find any suzuki page in MFD.

Question about :

1.Can we have SUZUKI ENGINE PAGE on TZT3 or GP1871 MFD? / How?

2. Suzuki Engine Page were only include in Suzuki's SMD MFD series?

3. Is any software can be update from FURUNO or Suzuki dealer ?

 

[Bayhouse]

Did you select the single outboard engine page? IIRC, once you open the engine data, swipe right/left to choose different configurations.

 

[Johnny Electron]

Suzuki proprietary setup pages and design layout is held by them for their MFDs. You have the most current software in your Furuno units by the sound of it. As @Bayhouse said, if the Suzuki gateway was setup correctly, normally you would turn on the ENGINE and go under HOME-SETTINGS-INITIAL SETUP and hit "Engine & Tank Automatic Setup" to set the MFD to see the incoming PGN data from the engine. At that point you can configure and view your engine instrument page how you like to lay it out. The data should show when the engine system is running.

 

[Jimmy]

Did you select the single outboard engine page? IIRC, once you open the engine data, swipe right/left to choose different configurations.

Hi Bayhouse,

Yes, with suzuki dealer do the configurations for gateway.
That's why we can saw the engine RPM / GEAR / coolent...etc.

Suzuki proprietary setup pages and design layout is held by them for their MFDs. You have the most current software in your Furuno units by the sound of it. As @Bayhouse said, if the Suzuki gateway was setup correctly, normally you would turn on the ENGINE and go under HOME-SETTINGS-INITIAL SETUP and hit "Engine & Tank Automatic Setup" to set the MFD to see the incoming PGN data from the engine. At that point you can configure and view your engine instrument page how you like to lay it out. The data should show when the engine system is running.

Hi Johnny,

That's clear for Suzuki page,
So far so good, already setting engine data on instrument page.

Thanks for you & Bayhouse advice.
Best,