Running 2 x 1kw 12 pin transducers into TZ touch XL

[Miytch_m77]

Hello all,
Looking for ideas / solution on how to run a SS175H and TM265LM into the TZtouch XL? Both transducers are 12 pin.

Thank you!

 

[Johnny Electron]

That isn't supported.

 

[Miytch_m77]

So we have established as a stand-alone unit it isn't supported, is there another way to possibly do it?

 

[Sparky Wire]

It isn't designed to connect to H,L, and M with one stand alone sounder. two freq Chirp sounder if not using side-scan. If side-scan is used it is single freq Chirp. There is no place that quotes L, M, H are all supported at once. Wishful thinking but it isn't supported.

 

[Miytch_m77]

It isn't designed to connect to H,L, and M with one stand alone sounder. two freq Chirp sounder if not using side-scan. If side-scan is used it is single freq Chirp. There is no place that quotes L, M, H are all supported at once. Wishful thinking but it isn't supported.

Thank you for your help. I'm guessing where I'm going then is there a way to have them all wired but I can select which to use rather than turning the sounder off, unplugging one and plugging the desired one in and turning the sounder back on?

 

[Johnny Electron]

It is not supported and likely to result in damage to the sounder at some point as removal and addition of load on the sounder is likely to be an issue. Inherently switch boxes and timing end up where the sounder has no load or the load is changing during operations even by accident resulting in very costly damage. While it is yours to experiment with and possibly damage as you wish, it is not supported. Our permission is not needed if you wish to do what Sparky says "let the smoke out".