Hello Experts!
I purchased a new furuno system this year and love it!
Only a few gaps listed below that I’m closing at the moment.
1. My heading sensor has gone out a couple times in rough seas (eventually came back after slowing down and rebooting). This one makes me the most nervous.
2. My 165T-TM260-200/50 DFF3D is only reading to 525’ in the Gulf Stream. All of the furuno videos say 1000’ in the Gulf Stream. Is it possible I have it configured incorrectly?
3. My thru-hull bronze B175M is only reading to 730’ in low fixed frequency (shallower in higher and chirp frequencies) in the Gulf Stream. Same as #2 above, all of the advertisements I’ve found show this transducer working in over 1000’.
I spoke briefly with my installer yesterday and was told that it could be interference between the units or water clarity. But I’m pretty sure I tested them independently and in the same Gulf Stream as the advertisement videos. Any suggestions? #1 is clearly the biggest issue at the moment.
Thanks,
DaVapors
I purchased a new furuno system this year and love it!
Only a few gaps listed below that I’m closing at the moment.
1. My heading sensor has gone out a couple times in rough seas (eventually came back after slowing down and rebooting). This one makes me the most nervous.
2. My 165T-TM260-200/50 DFF3D is only reading to 525’ in the Gulf Stream. All of the furuno videos say 1000’ in the Gulf Stream. Is it possible I have it configured incorrectly?
3. My thru-hull bronze B175M is only reading to 730’ in low fixed frequency (shallower in higher and chirp frequencies) in the Gulf Stream. Same as #2 above, all of the advertisements I’ve found show this transducer working in over 1000’.
I spoke briefly with my installer yesterday and was told that it could be interference between the units or water clarity. But I’m pretty sure I tested them independently and in the same Gulf Stream as the advertisement videos. Any suggestions? #1 is clearly the biggest issue at the moment.
Thanks,
DaVapors