A
Anonymous
Guest
I have a new system installed right from the builder. I turn on the plotter and go through the installation wizard. There is the MFD12, DRS4D, and DFF1 on the system. It goes through a generic hub, not Furuno HUB101. The installation wizard will not recognize the DRS4D or DFF1.
I then bypass the ethernet switch and plug the ethernet cable directly into the back of the MFD12. The installation wizard recognizes the sounder and the light is blinking on the module. I think great, that is all I have to do with the radar. I do the same with the radar and the installation wizard still does not recognize it?
At this point I am thinking a cable issue? Connections are tight, I have 51vdc at the radar power plug.
I then bypass the ethernet switch and plug the ethernet cable directly into the back of the MFD12. The installation wizard recognizes the sounder and the light is blinking on the module. I think great, that is all I have to do with the radar. I do the same with the radar and the installation wizard still does not recognize it?
At this point I am thinking a cable issue? Connections are tight, I have 51vdc at the radar power plug.