Connecting new c285c-hw-11r to a TZT3

Fish On

New member
Over winter project I'm getting a TZT3 16". Hoping I like the TZT3 & eventually do a complete refit with 3; TZT3 16" open Array Radar, Autopilot, AIS, DFF3D, 2kw LH Transducer, VHF, Etc....
Current transducer I have is a B285C-HW-11R working with a RM Axiom Pro.
My question, will the B285C-HW-11R work with a TZT3?
OR, what cable or splice box is needed to make this happen. Please advise,
Thanks.
 
Hey Fish On,

Yeah you can. You would need to cut the connector off of the transducer cable and then purchase and wire it into our TZT3 transducer cable.

Wiring it looks easy, looks like you would just use the blue wire off of the transducer and onto blue wire off of the TZT3 cable and and black wire off of the transducers cable onto black wire of the TZT3 cable. You can match up the temperature wire too.

Links below should help guide you through this.


TZT3 Transducer Cable - https://furunousa.com/en/products/tz3-12p-pgt
TZT3 Cable Wiring Diagram - https://furunousa.com/-/media/sites...nd_installation/12pin_xdr_pigtail_pin_out.pdf
C285C-HW-11R Wiring Diagram https://www.gemeco.com/UserFiles/Documents/9/91-1393.pdf
 
Back
Top