1934C-BB Navnet VX2

[Anonymous]

I am having issues with the display being slow to update and it has been suggested that I download the upgraded software and install it to my 1934C-BB. Purchased 2006.
Can you please provide the link to the website from which I can download the upgrade software?
Thanks

 

[Johnny Electron]

If your unit is running Navionics programming, you will find the software under the 1934CBB product page (under the tab "Software")

Here is a direct link to the product on our web site.
http://furunousa.com/Products/ProductDe ... ct=1934CBB

 

[Anonymous]

Thanks Johnny,
I am running C-Map charts.
Can you please provide the link to this software?
Thanks greatly
Pookanah

 

[Johnny Electron]

Providing a link directly to the software will bypass the users agreement you must agree to. Please use the link I provided and click "SOFTARE" tab then agree to the software terms to access the free software.

 

[Anonymous]

Hi Johnny,
Thanks for the assistance so far. I am happy to agree to the users agreement. However, the link you provided in you original response only shows the update for Navionics. In my case, I am using C-Map charts. Maybe I am wrong, but I would expect to have to use a C-Map update and NOT the Navionics update.
Your assistance is most appreciated.
Pookanah

 

[Melville]

Pookanah-
Here you go:
http://www.furunousa.com/Products/Produ ... t+Plotters

 

[Johnny Electron]

As a side note a 1934CBB is a Navionics unit.

A 1934CBB/NT is a C-map unit. Since the manuals list all the models, I recommend highlighting the correct number that applies to your unit to prevent misunderstandings in the future.

Thanks for hooking him up Melville.

 

[Anonymous]

Thanks Guys,

I will give you an update once I have installed it and used it a few times.

Thanks & All the Best
Pookanah

 

[Anonymous]

Hi Guys,

An update as promised.
Firstly, the installation of the new software is straightforward and is easy to do by following the provided instructions. Well done!
However, I do have one issue. All works fine (much better than before), but, the chart (C-Map M-AU-M005) does not display correctly when the range setting is 16nm. I have, on one occasion, experienced this on the 8nm range also. Is this a Furuno issue? or is this a C-Map issue?
Can you please advise on this issue?
Thanks & Best Regards
Pookanah

 

[Johnny Electron]

I am not aware of any chart issues when using current software. It could be that the surveys for that area stop or don't have anything lower than a set level. This area is outside the Furuno USA sales and support area. Please contact your local Furuno distributor for Australia for the best information in that area.