Tom Stewart
New member
Current setup:
B265LH Bronze Thru-Hull CHIRP Transducer - 12-Pin
MFD12 Navnet 3D
DFF1 UHD
DRS 6A Radar - 4' open array
GP330B gps
I do understand that I have to add the PSU 012 for the radar to function as well as updating the DRS software.
My problem is that it is an absolute nightmare to run another cable from the radar to the helm where the display is located.
If I understand the schematic, I have to run a lan wire from the radar motor housing to the PSU and another lan wire from the PSU to the display.
If there is a LAN wire running from the radar motor to the display NOW, can I not just mount the PSU behind the display and add a LAN cable from the PSU to the display?
Hope this makes since.....
Thanks,
Tom
B265LH Bronze Thru-Hull CHIRP Transducer - 12-Pin
MFD12 Navnet 3D
DFF1 UHD
DRS 6A Radar - 4' open array
GP330B gps
I do understand that I have to add the PSU 012 for the radar to function as well as updating the DRS software.
My problem is that it is an absolute nightmare to run another cable from the radar to the helm where the display is located.
If I understand the schematic, I have to run a lan wire from the radar motor housing to the PSU and another lan wire from the PSU to the display.
If there is a LAN wire running from the radar motor to the display NOW, can I not just mount the PSU behind the display and add a LAN cable from the PSU to the display?
Hope this makes since.....
Thanks,
Tom
