SST Not available on 2nd unit

[DeepSouthTX]

I have a tzt3 16 that has my main transducer and a dff3d. Both have temp. On the 16 I can set a graph with temp data over a certain time frame which I use alot. On my 2nd unit a tzt12f connected via network I can see SST on the initial setup sources and select either tzt16 or dff3d. But when I go to add the graph on the chart data section its greyed out?? Any suggestions? Could this be a bug?

 

[Johnny Electron]

I think the data is grayed out because you already have SST in the NAVbox as numeric. If you want a graph; just change the numeric data to graph. It won't let you have SST twice on the same NavBox.

 

[DeepSouthTX]

I think the data is grayed out because you already have SST in the NAVbox as numeric. If you want a graph; just change the numeric data to graph. It won't let you have SST twice on the same NavBox.

Maybe I missed that. I will double check and report back.

 

[DeepSouthTX]

Yes that was it. Simply change to graph and I was good. Thanks

 

[Johnny Electron]

:respect :respect :jump :jump