Navpilot 300 tuning

[cbernacki]

My pilot tends to wander at low speeds. More than i think it should compared to my previous pilots.
I have it set in Precision mode and verified that the hydraulics are bled correctly but i cannot seem to stop it from wandering excessively.
At speeds above 8 mph it work good but at slow trolling speeds it seems like it cannot keep up and then give a Mag Var alarm as it wanders further and further.
Any tips on what settings i can use the help counter this would be helpfull.
I have a TZT2, PG700 and a type I pump

Thanks

 

[Johnny Electron]

Try Eco mode, ensure the dockside and rudder test have been done in the water not out of the water. Ensure that the Hydraulics have been bled, no air. What is the hard over to hard over time (in seconds)?

 

[cbernacki]

Hard over to hard over is about 12-14 seconds.
Hydraulics have been bled.
I was in Advanced auto mode and i think that was just too much with the swell for the pilot to keep up.
I will check theses items tomorrow.
Thanks for the reply