Nav et vx2 and fax-30 - connection.

[Globule]

Hello,
I have 2 chart plotters of 10 ‘4 navnet vx2, connected by the network port. I have a fax-30 that is connected to a wifi router. I want to connect the fax - 30 to one of the plotters. Can I connect it to a data port ? Is a T adapter for the network port existing ? What is the hardware needed ? I fail to find info. Thank you for your help.

 

[Johnny Electron]

Fax30 is a NETWORK item. It would connect to the same ethernet network with the Vx2.

 

[Globule]

Is there a way to connect the fax-30 And the second plotter on the same port and how to do if yes ?

 

[Johnny Electron]

Multiple network items connect together via a hub/switch.

 

[Globule]

What kind of switch/ hub are you talking about ?

 

[Johnny Electron]

Back in the Vx2 days many used a PC Concepts hub so they could use the round connections but most use a low cost NetGear or TP link switch.

 

[Globule]

I miss a cable to go with a hub. Is there a protocol to access fax-30 via windows 11 ? I try via rj45 connection (direct to PC & via a hub ( netgear)), enable edge to charge as internet explorer, typing the requested URL in the browser, but can’t even detect it in the local network.

 

[Johnny Electron]

If wiring your network cable direct it must be a cross over cable. If using a newer hub, they are auto sensing so either a straight or cross over will work. One must turn off the items that block communications like antivirus and firewalls. The computer must be set to the correct IP address and subnet mask as explained in the manual. If the PC is addressed correctly it should be able to bring up the internal HTML page from the Fax30 whenever the fax 30 address is typed into the browser.