MFD8 software update 2.11~>2.13

[larion]

Hello. I took my old NavNet 3d MFD8 device off the shelf. I want to update it to the latest software version.

1. I downloaded the file "MFD8-12 1950055 0213" and wrote it to an SD card (FAT system - 1 gigabyte)
2. Following the instructions, I inserted the card into the top slot and turned on the device. I made two confirmations. The device loaded.
3. The device's properties still display version 1950055-02.11
4. I also tried with a FAT32 system SD card. I also tried with the "MFD8 MFD12 v.02.13" file that I downloaded from the same place.
I didn't understand which one was correct or why there were two.


In any case, after all attempts, the version number remains in the properties of my device ....2.11

What should I change in my actions to update the software?
Should I install a intermediate version of the program before upgrading from 2.11 to 2.13? If so, which one?

 

[larion]

I used the algorithm specified in this instruction.

I also tried a video instruction from YouTube.

They differ in small details. But there is no effect.

 

[Johnny Electron]

Sounds like you are attempting to use a very large SD card. You can not use anything larger than a 32GB chip and it must be done via a PC not a MAC/Apple.

 

[larion]

Sounds like you are attempting to use a very large SD card. You can not use anything larger than a 32GB chip and it must be done via a PC not a MAC/Apple.

I'm using a 1-gigabyte card! I mentioned this in my message. The card was prepared on a Windows PC.

 

[Johnny Electron]

Can you do a screen capture of the what his shown on the root of the SD card being used?

 

[larion]

Can you do a screen capture of the what his shown on the root of the SD card being used?

Yes, I can. Unfortunately, I'm far away from my computer right now. I'll do it later. Thank you for your feedback.