Hi all,
I have a NavNet TZtouch XL 10x and a 165T-50/200-SS260 DFF3D 50/200 Stainless Combination Thru-Hull transducer, Module DFF3D and SXC-20
the TZT MFD has the lastest firmware 25.21, DFF3D and SCX-20 too.
When I config the TZT SCX 230 is detected though NMEA2000 and I can configure it internally under his specific menu. I have put some degree compensation on the pitch and roll to make it right but even having the heave compensation activated I cannot see it working. so at the end I have my doubts that all my PBG is wrong as it didnt compensate the waves. I ve checked all the manuals and I can´t find where is the issue. I´m attaching several screenshots to see my config and see if someone that has been on same situation can help me. in the sonar view it´s clear that the heave is not working at all as the bottom seabed is with waves.
Any Ideas?
I have a NavNet TZtouch XL 10x and a 165T-50/200-SS260 DFF3D 50/200 Stainless Combination Thru-Hull transducer, Module DFF3D and SXC-20
the TZT MFD has the lastest firmware 25.21, DFF3D and SCX-20 too.
When I config the TZT SCX 230 is detected though NMEA2000 and I can configure it internally under his specific menu. I have put some degree compensation on the pitch and roll to make it right but even having the heave compensation activated I cannot see it working. so at the end I have my doubts that all my PBG is wrong as it didnt compensate the waves. I ve checked all the manuals and I can´t find where is the issue. I´m attaching several screenshots to see my config and see if someone that has been on same situation can help me. in the sonar view it´s clear that the heave is not working at all as the bottom seabed is with waves.
Any Ideas?
