Fcv295 transducer settings....

[Chewbucca17]

Hi guys. Would anyone happen to know how to set up on the fcv295 settings(the transducer menu) to use a r109hl transducer for the high and low side?
Thanks for any help

 

[Snips]

Chewbucca17,
I would start with setting the LF side at 38Khz, band width at 19Khz using Tap "B".
The HF side at 200Khz, band at 40Khz and using Tap "C".

Snips

 

[Chewbucca17]

Thanks snips. On the attached pic, how would I complete the setup menu? What would i put in for transducer and transducer select etc?

 

[Snips]

Chewbucca17,
Change XDR SELECT from Type to Manual, then enter the values.

Snips

 

[Chewbucca17]

Thanks snips . What do i put under transducer ? Is r109 in the menu?

 

[Snips]

Chewbucca17,
The R-109 is not in the menu.
That is why you need the input the settings manually.

Snips

 

[Chewbucca17]

Cool. Thanks snips ! :furuno

 

[marciocarvalho]

Would anyone happen to know how to set up on the fcv295 settings (the transducer menu) to use an airmar R309 transducer for the high and low frequencies sides?
I would like to know the LF and HF side frequency, band width and TAP....

 

[Deep Blue]

marciocarvalho,

These are the following TAP Settings that you need to set your FCV295 for use with the R309 Transducers:
For the Low Frequency side of 38kHz use Tap C Setting and for the High Frequency side for 150kHz, then use a Tap D Setting

- Deep Blue