Bubbles
- Thread starter MikeR13
- Start date
If it is under warranty (two years), I would recommend contacting your closest Furuno Dealer. If it is outside of warranty; I would send it to the Furuno Service Center.
Thanks! i will be pulling the boat for the season this week and I will send it in. Is there any forms I need to fill out to identify the problems? Secondly, I would like to have the freezing of the sonar looked at. When I try to run the sonar from my tzt2 on my tzt it freezes on the tzt. Thanks for the prompt response.
No RMA required, just send it in with a letter describing what you want evaluated and they will call you after they evaluate it.
Furuno USA Service
4400 NW Pacific Rim Blvd
Camas WA 98607
Furuno USA Service
4400 NW Pacific Rim Blvd
Camas WA 98607
H
harbourvilla
Guest
I had the same thing happen to both my TZT14s. They were out of warranty but they still fixed them. I guess there was a manufacturing issue. Furuno is very good. Shipping cost with insurance was outrageous thru UPS, like $375 a unit. But Furuno also updated the software. So it was well worth the expense and trouble to pull the units and ship them off. Than you Furuno. A class act.
topcorner18
Member
I know this is an older chain but just wanted to be sure Johnny's comment still applies regarding where to return for repair. Both of my TZTouch 14" displays pretty much developed bobbles at the top-right display corner at the same time. Do I still send them to the address listed above? Are these fixed under warranty?
Thank you
Thank you
If the unit's are under warranty, it is repair repaired as such. Some special programs are in place for anyone outside of warranty. I recommend you contact tech support with the serial numbers to check status and details prior to sending in.
topcorner18
Member
Thanks
Similar threads
