BTW and Next Course To Steer Not Appearing in Data Boxes on Active Route

[JMadera]

I have 3 TZTBB connected to 2 x 24” Hattland and 2 x 12” Hattland displays in the pilothouse and 2 x 14 TZT Furuno displays on the flybridge. All working flawlessly until now.

I have several data boxes in the Data 1 and Data 2 boxes displayed on the side of the chart according to personal preference. I had a route activated and was navigating on the route. The Highway graphic and XTE to the next waypoint were displayed correctly as well as DTW and TTG to the next waypoint. Also, the DTA at the end point of the route was displayed correctly as well as the TTA and the ETA.

What is NOT displaying correctly in the data boxes are the BTW (Magnetic) for the active waypoint and the next course to steer (Magnetic) for the next waypoint after reaching the current, active waypoint.

Do you have any insight as to why the DTW and TTG to the next waypoint would be accurately displayed while the BTW and the next course to steer would not? Everything else in relation to the active route appears to be working correctly.

Thanks!

 

[FishTech]

Can you post photos of your complete Sensor List and Data Sources? Home - Menu - Initial Setup - Data Sources. Sensor List is the next option below that.
We can tell a lot from there.

 

[JMadera]

Can you post photos of your complete Sensor List and Data Sources? Home - Menu - Initial Setup - Data Sources. Sensor List is the next option below that.
We can tell a lot from there.

Thanks. I was finally able to get back to the boat. Here are the photos you requested (in 3 batches of 3)

 

[JMadera]

Thanks. I was finally able to get back to the boat. Here are the photos you requested (in 3 batches of 3)

 

[JMadera]

Last batch

 

[JJ Neutron]

Here is something to try: In Menu-Units, change Bearing Reference to True and it should come back.

 

[JMadera]

Thanks. I will try that......but if the value is set to True and I want the BTW in Magnetic will it display the value as a Magnetic value? Or should I set it to True, wait for the True value to display and then change it back to Magnetic?

 

[JMadera]

Here is something to try: In Menu-Units, change Bearing Reference to True and it should come back.

I have set the value to True in Unit settings. The BTW does come back (which is great) but of course my displayed heading value is True and the BTW is also True. As soon as I switch the Units back to Magnetic, my heading value changes to the proper Magnetic heading value but the BTW disappears. So it appears that if I want the BTW I can only display it if my Menu setting values are True. Which does not work for me because I need the values displayed as a Magnetic heading and Magnetic BTW. Any further thoughts on what I could do?