Bruce Clarkson
New member
I have recently upgraded to a Furuno 1815 radar. So far, so good except:
I put EBL1 and VRM1 on the display. Manipulated them as needed except I cannot remove them. Indeed I have read the manual (maybe not correctly).
I use the mode menu. I select EBL. A two line submenu of "EBL1" and "EBS2" is displayed.
EBL1 is selected by default. I press the "Menu/Esc" bottom at the top right. The EBL line continues to be displayed. BTW, the displayed line is EBL1 as I can otherwise manipulate it just fine.
Similarly, I cannot remove the VRM1 ring I have displayed.
What am I missing? Is there an updated needed to the manual? Perhaps I'm just reading the instruction incorrectly?
Thanks in advance for any help,
Bruce Clarkson
I put EBL1 and VRM1 on the display. Manipulated them as needed except I cannot remove them. Indeed I have read the manual (maybe not correctly).
I use the mode menu. I select EBL. A two line submenu of "EBL1" and "EBS2" is displayed.
EBL1 is selected by default. I press the "Menu/Esc" bottom at the top right. The EBL line continues to be displayed. BTW, the displayed line is EBL1 as I can otherwise manipulate it just fine.
Similarly, I cannot remove the VRM1 ring I have displayed.
What am I missing? Is there an updated needed to the manual? Perhaps I'm just reading the instruction incorrectly?
Thanks in advance for any help,
Bruce Clarkson