I'm looking to install the Flir and integrate with my NN3D setup. This is not a Pan/Tilt model, it is fixed.
These are my understandings:
It has a BNC connector that will plug into the MFD12, therefore i can only view it on the MFD it's plugged into. It will not be available over the network, similar to the cameras.
questions:
Is there a way to make it available across the network?
Does NN3D have software controls for the various Flir cameras or do I need to buy the separate controller?
Do i need to power it on before or after the NN3D network for it to be seen? Or does it not matter.
Can it be powered on by the hub101?
Thanks for any help
These are my understandings:
It has a BNC connector that will plug into the MFD12, therefore i can only view it on the MFD it's plugged into. It will not be available over the network, similar to the cameras.
questions:
Is there a way to make it available across the network?
Does NN3D have software controls for the various Flir cameras or do I need to buy the separate controller?
Do i need to power it on before or after the NN3D network for it to be seen? Or does it not matter.
Can it be powered on by the hub101?
Thanks for any help