I have installed an Actisense NMEA converter to transmit Sat compass SCX-20 heading data to a Navpilot 500 autopilot. I am troubleshooting an issue with the heading updating only when I turn on the AP, then the heading data does not refresh. What baud rate should I be using in the Actisense config? Second question. Is it possible to use the NMEA0183 output from the TZT2BB to provide heading data to the AP, assuming the heading data in that case would come from the SCX-20 sat compass on the network. This would eliminate the need for the Actisense converter wouldn't it? Thanks for your input.