Zt14,bdds1,1kw trans,radar ,AP,fusion Radio, weather

[C-Bass]

Good afternoon Lionheart,

The when there is a mixed product installation, like the one you have, that has both the TZT and MFD8 (nn3d) the TZT should not be connected to NMEA2000, only the MFD8 should be connected to the NMEA2000 bus.

Please see the link below that will take you to a TZT installation check list. Please reference the chapter that explains TZT and NN3D mixed installation (starts on Page 5)

https://www.furunousa.com/-/media/s...als/navnet_tztouch_installation_checklist.pdf

Kind Regards,
C-Bass

 

[C-Bass]

Good afternoon Lionheart,

The version number that you provided is from the Installation Wizard, unfortunately that is not a number that we use.

To find the current version of software on you MFD8 please allow the system to boot fully. Then his the [Menu] button, the scroll all the way down to the "My NavNet" tab. In that tab you will see software version number, please provide that version number.

Kind Regards,
C-Bass

 

[Lionheart]

Correction:The tzt14 does not turn on the mfd8 but it does turn it off
VERSION 1950055-02.11

 

[Lionheart]

I have been tracing some connections
and the mfd8 is connected, the tzt24 is not

 

[Lionheart]

Oops I have been doing startup wrong .
installer says he will get 2.13 and install it

 

[C-Bass]

Master Reset needs to be done before and after the update.

Please see link below.

https://www.furunousa.com/-/media/s...ombo_update_instructions_mfd8_mfd12_v2.13.pdf



This will be my last post on the subject. If you need additional help you will need to start a new thread.

Kind Regards,
C-Bass

 

[Lionheart]

Ok thanks very much for your help.
I will see what happens in next days