Recently purchased a TZT3 19 MFD with Version 2 software. Not installed on my boat yet, but have the unit operating at home in a bench setup environment with 12 vdc supplied and only a NMEA 2000 bus network connected. Set up the MFD wireless LAN in LOCAL mode, set the MFD to DEMO mode and separately booted the N=Remote and N-Viewer apps (not simultaneously) on my iPad Pro. N-Viewer app appears to work fine, but the N-Remote app presents a "Searching for NAVNET" message on the home screen when booted. Changing the app operating mode and/or screen resolution has no effect.
I followed the most recent TZ/TZT2 app guide (Version 6) in setting this up. I am using a first generation (2015) iPad Pro operating with iOS 14.6. Booting the Remote app on an iPhone X (also with iOS 14.6) results in the same symptom.
Since the N-Viewer app is working, it would seem the LOCAL mode wireless interface between the MFD and my iOS devices is functioning properly. I remember seeing a previous thread (TZT2 board?) regarding a compatibility issue with one of the apps using iOS devices with version 14.x software but Apple made a software change that corrected the issue.
Looking for thoughts and suggestions on possible causes and/or solutions.
I followed the most recent TZ/TZT2 app guide (Version 6) in setting this up. I am using a first generation (2015) iPad Pro operating with iOS 14.6. Booting the Remote app on an iPhone X (also with iOS 14.6) results in the same symptom.
Since the N-Viewer app is working, it would seem the LOCAL mode wireless interface between the MFD and my iOS devices is functioning properly. I remember seeing a previous thread (TZT2 board?) regarding a compatibility issue with one of the apps using iOS devices with version 14.x software but Apple made a software change that corrected the issue.
Looking for thoughts and suggestions on possible causes and/or solutions.