C
Catmando
Guest
I recently installed a couple of TZT2 15's, DRS12A, Navpilot 711, etc. and finally got everything up and running last week. I just noticed this morning however that the DRS has been powered up in stand-by mode since I splashed the boat last week, showing over 200 hours (less than one in transmit mode). During my install I emailed Furuno Support about a disconnect switch and was told to let the TZTouch's power down the network. Obviously I misunderstood something along the way or have something setup incorrectly. So does anyone know if there any way to have the TZT2's power down the DRS/PSU-012 or do I need to install a separate disconnect switch?
I also noticed that when I configure an instrument screen on one of my MFD's, it over-writes the instrument screen on the second MFD. In fact all the settings seem to mirror across the two TZT's. Is this something that can be configured? On one hand I like the idea of not having to recreate a screen but on the other hand I like the idea of having different screen's/settings across the two displays.
Thanks
I also noticed that when I configure an instrument screen on one of my MFD's, it over-writes the instrument screen on the second MFD. In fact all the settings seem to mirror across the two TZT's. Is this something that can be configured? On one hand I like the idea of not having to recreate a screen but on the other hand I like the idea of having different screen's/settings across the two displays.
Thanks