TZ3 Transducer question

[SC_HAMACHI]

Looking at upgrading my system to the new TZ3 with the following components.

SCX-20
DRSD-NXT radar
DFF3D
165t-50/200 transducer. My question is will this transducer come with 2 pig tails? I have a 585 I would like to have the 50/200 work with and the 165 hz element drive the DFF3d.

Thanks,

Kyle

 

[Johnny Electron]

The combo transducer will have three cables as shown under the combo transducer model number of the DFF3D transducer guide.

https://www.furunousa.com/-/media/sites ... _guide.pdf

One is a 10 pin transducer cable that can be used to the FCV585 if you wish. The other two (transducer wires and pitch/roll sensor wire) go over to the DFF3D for it's use.