D
danny
Guest
i have radar 1932 mk2. it used E3571 magnetron, and its TX hours is 5000. before i change with new magnetron, the echo was still fine.
after i change with new MG4004 magnetron, echo didnt show up, just small 3 or 5 dots green, i set up 40% gain. then i set 100% gain, the echo become many dots green and almost cover all screen.
when its going wrong with the new one then i change magnetron again with the old one. i hope it become normal again but its wrong. the echo still same, many green dots cover all screen.
plis any one , can you help me with test point voltage that normally work on each card so i can decide which one is broken.
thnks
danny
after i change with new MG4004 magnetron, echo didnt show up, just small 3 or 5 dots green, i set up 40% gain. then i set 100% gain, the echo become many dots green and almost cover all screen.
when its going wrong with the new one then i change magnetron again with the old one. i hope it become normal again but its wrong. the echo still same, many green dots cover all screen.
plis any one , can you help me with test point voltage that normally work on each card so i can decide which one is broken.
thnks
danny