I am in process of upgrading firmware on RPD-139 on an older boat located outside US. I need to make up a network cable to connect the Display (MJ6 6 pin) to Laptop with RJ45. No Furuno factory MJ6 to RJ45 cables on Island but have located a used MJ-A6SPF0014 with an MJ6 6 pin end and have standard Ethernet cables at the local Computer store.
It will be a direct connection between the laptop and the RPD-139 Display as there is no network hub. Therefore the cable will need to be a cross over.
Does anyone know the pin out for a cross over connection with MJ6 6 Pin and RJ45 Connector?
Thanks
Andrew
It will be a direct connection between the laptop and the RPD-139 Display as there is no network hub. Therefore the cable will need to be a cross over.
Does anyone know the pin out for a cross over connection with MJ6 6 Pin and RJ45 Connector?
Thanks
Andrew