F
Futuro
Guest
Hello everyone,
I trying to connect the PG-500 heading sensor to the FAP-7002 processor unit.
I connected it as shown in manual the following way:
In the PG-500 the 12/24VDC port - black and red cables connected to the power source, all others isolated.
In the PG-500 the NMEA - cables connected to the TB6 port 1 of the FAP-7002 this way: Yellow(to 1), Green(to 2), White(to 3), Black(to 4) and shield.
When I turning on the autopilot the display says: heading sensor "NG" and the PG-500 slowly blinks.
This is an deviation error or I connected wrong way, or wrong port? :sorry What I should do? :think
Thank you!
P.S this set worked together in another ship, but I don't know how they had it connected.
I trying to connect the PG-500 heading sensor to the FAP-7002 processor unit.
I connected it as shown in manual the following way:
In the PG-500 the 12/24VDC port - black and red cables connected to the power source, all others isolated.
In the PG-500 the NMEA - cables connected to the TB6 port 1 of the FAP-7002 this way: Yellow(to 1), Green(to 2), White(to 3), Black(to 4) and shield.
When I turning on the autopilot the display says: heading sensor "NG" and the PG-500 slowly blinks.
This is an deviation error or I connected wrong way, or wrong port? :sorry What I should do? :think
Thank you!
P.S this set worked together in another ship, but I don't know how they had it connected.