Navnet mfd12 don't start

[Diegosub]

the display won't start and says this message on the screen.
Can someone help me?
Regards

 

[Johnny Electron]

If the unit won't start up, I would recommend ensuring that proper power levels are in place. If still having an issue, disconnect everything from the unit expect the power cable and ensure that the USB and card reader slots are empty, then try it. It is always good to cut things down to the simplest form and get that working and then slowly add back the complexities.

 

[Diegosub]

Thank you for your reply. The screen turns on, but this message appears. Did you see it in the images I attached?

 

[Johnny Electron]

Yes, I saw the photos you included.

 

[Sparky Wire]

I agree lots of things can cause that error. Got to start with the basics. If it doesn't power up on good power without anything connected, I would try programming it as the next move. I wouldn't jump to that right away, because it could be many other things besides software.

 

[Diegosub]

I agree lots of things can cause that error. Got to start with the basics. If it doesn't power up on good power without anything connected, I would try programming it as the next move. I wouldn't jump to that right away, because it could be many other things besides software.

The power is ok and there is nothing more connected other than the power cable. I also have nothing in the SD card slot. Can you help me with this programming?

 

[Diegosub]

If the unit won't start up, I would recommend ensuring that proper power levels are in place. If still having an issue, disconnect everything from the unit expect the power cable and ensure that the USB and card reader slots are empty, then try it. It is always good to cut things down to the simplest form and get that working and then slowly add back the complexities.

The power is ok and there is nothing more connected other than the power cable. I also have nothing in the SD card slot. Can you help me with this programming?

 

[Johnny Electron]

Full software and instructions are posted under the MFD12 product page of the website.
Here is a direct link.

MFD12

www.furunousa.com