I have a lot of Displays, TZT, 2x FI 70, RD33 and of Course the 711c. Of Course you are right, it is possible to set a value for wind damping within the Autopilot Setup, but as far as I understand thats only for ap behavior when in vane mode and with an AWA > 55 degrees. But what I Need is to smoothen the wind angle at the Display, I use the readout at the 711 alot because ist Close to the helm. Not very surprising that the AP reacts to the jumpy AWA values quite worse. It was no Problem with the "old" FI50 Wind Instrument because smoothing was done right there and the "softer" values are transferred in the N2K Bus.
So, is there any way to smoothen the raw-data coming from the ifnmea the same way the FI50 Wind unit did?