FA50 showing steady red ER light

ride5k

New member
As the title states, my FA50 is showing a steady red "ER" LED. From what I've read this should be the case while the unit is initializing but not thereafter. Has anyone seen this behavior before, and if so what was the final outcome? I have tried power cycling the unit with no change.

Thanks in advance,
Ken
 
Bad Whip antenna with too much reflected signal can cause that also. Sounds like it should be sent in for a full check out.
 
Me too.

ER_LED lights up, then blinks, then repeats. I waited 30 minutes, but nothing changed. Also, the ethernet connector LED doesn't light up. (Cannot access from PC) What I tried is to replace the power supply and connect a dummy load to the antenna terminal.
 
Back
Top