Hi ,
I have a DRS4D that was working for 8 moths ,but after upgrading the PC I can not connect to it, even on the old pc as well. I have power getting to the dome, the hub is blinking, I can ping the address from the PC ( it does have a 10ms delay instead of 0-1 like AIS and DFF1).
I saw in a earlier post I can connect a standard Ethernet cable to the dome and test it that way. Are there any other checks to see is the dome is OK short of pulling it off and taking ti a service center. Is there any other tests?
I am direct tot he PC so I dont have a MF display.
thanks Luke
I have a DRS4D that was working for 8 moths ,but after upgrading the PC I can not connect to it, even on the old pc as well. I have power getting to the dome, the hub is blinking, I can ping the address from the PC ( it does have a 10ms delay instead of 0-1 like AIS and DFF1).
I saw in a earlier post I can connect a standard Ethernet cable to the dome and test it that way. Are there any other checks to see is the dome is OK short of pulling it off and taking ti a service center. Is there any other tests?
I am direct tot he PC so I dont have a MF display.
thanks Luke