DRS2DNXT mount

[jdbravo]

Hello,


I recently ordered a DRS2DNXT and plan to install it on a T-top canvas boat. According to the documentation, it requires a 25° vertical clearance without obstructions.

I want to avoid making holes in the canvas, so I’ve designed a support structure that attaches to the edges of the T-top. Do you think this setup will work properly and meet the clearance requirements?

Thank you for your assistance!

Best regards,

 

[Titanic II]

The 25 degrees is total...12.5 up and 12.5 down as measured vertically from the center of the white part of the dome assembly. The only suggestion I would make to improve this just a bit is to mount the RADAR on the front side of the top if possible. This will allow more RF energy to bounce of close-in targets such as a crab pot. Just a note that the RADAR does have a minimum range of approx. 70 feet (the RADAR is still transmitting and settling to listen mode in the first 70 feet).