DFF3D with 165T-B54 will no longer provide cross section return.

S

sjmeyer

New member
After a haul out in Dec 23 my DFF3D no longer provides good signal in any direction but vertical.

3d.png



IMG_1023.jpg
I have updated the DFF3D to latest firmware and reset to factory settings.
Using TZTL15F and TZT9F MFDs. Incorporated in the network are two TZERO Pro setups with latest software.
for trouble shooting the TZERO systems are shut down.

What is my next step?
 
sjmeyer,

I'd check all the connections going into DFF3D, including the transducer's connections. Then try doing a factory reset of the unit to see if clears the unit...

- Deep Blue
 
Last edited:
Re-terminated transducer cable taking extra care with grounding. Did factory reset by powering up with dip switch 4 in on position.

No improvement. Anything else to try?
 
sjmeyer,

At this point, I recommend that you have the transducer checked by a local Authorized Furuno Dealer. :unsure:

- Deep Blue
 
sjmeyer said:
Re-terminated transducer cable taking extra care with grounding. Did factory reset by powering up with dip switch 4 in on position.

No improvement. Anything else to try?
Click to expand...
Hello sjmeyer

I have a customer with similar problem, but no cross section. Did you find any solution on your problem?

Frank
 
You must log in or register to reply here.
Back
Top