DFF3D Sounder History not working properly

[ELGATODOS]

So we "upgraded" the software to the 7.01 and it's been a struggle to get the settings back to where I had them, sort of screwed up and didn't copy anything down. Not like the DFF3d has a lot of options.

My biggest issue is the Sounder History screen only paints what's under the boat when there is motion or something to print and then stays there. Before it would consistently scan and record no matter is it was seeing the bottom or fish.

I want it back to the way it was, what's the solution?

 

[Johnny Electron]

The sonar settings are stored in the DFF3D. You could always try going back to v6 software on the unit but I don't think it is related. There is newer DFF3D software available that sets up the factory presets to make it easier to get good results out of the box. You might try upgrading to that software and see if that helps.

 

[ELGATODOS]

The sonar settings are stored in the DFF3D. You could always try going back to v6 software on the unit but I don't think it is related. There is newer DFF3D software available that sets up the factory presets to make it easier to get good results out of the box. You might try upgrading to that software and see if that helps.

Thank you.
What is the newer software called or what is its number?
I can see what we have currently installed.

 

[Johnny Electron]

Version 1.05 was released in June (2020) and posted on our website under the product (DFF3D) page at www.FurunoUSA.com. Hopefully that puts everything into a better setup.