I have a Furuno DFF3 sonar module (up to 3 kW) and I'm going to install an Airmar R299 transducer (2-3 kW), but I'm not sure if the Furuno DFF3's configuration is correct. I'm sending you pictures; can you help me?
DFF3 with Airmar R299 transducer (2-3 kW)
- Thread starter golosines
- Start date
golosines,
If you are going to utilize the R299 Transducer connected to the DFF3, then you'll need to change the Tap Settings for the DFF3 to the following: Low Frequency is Tap "C", and the High Frequency is Tap "A".
What is the MFD that are you using to connect this DFF3 too...?
- Deep Blue
If you are going to utilize the R299 Transducer connected to the DFF3, then you'll need to change the Tap Settings for the DFF3 to the following: Low Frequency is Tap "C", and the High Frequency is Tap "A".
What is the MFD that are you using to connect this DFF3 too...?
- Deep Blue
I am using a computer with Timezerogolosines,
If you are going to utilize the R299 Transducer connected to the DFF3, then you'll need to change the Tap Settings for the DFF3 to the following: Low Frequency is Tap "C", and the High Frequency is Tap "A".
What is the MFD that are you using to connect this DFF3 too...?
- Deep Blue
Similar threads
