DFF3-UHD to R509C-LHW to TZT3

[Kicksave]

Getting ready to energize my new 3kw ducer.
I think my taps are correct. I'm only seeing 1 drain wire yet there are a few positions in the diagram. Is this correct?
I am going to have the DFF on its own 24V power switch
Are there any settings or heads up I need to know about before getting this beast fired up?
Thanks in advance.

 

[Deep Blue]

Kicksave,

Everything looks good. I would expose the transducer's outer shield and then make sure that's its attached to the transducer clamp. This will ensure a good transducer shield.

Also don't forget to go into your TZT3 [Settings] and select [Fish finder] menu, then select the [DFF3-UHD] as your primary sounder.

- Deep Blue

 

[Kicksave]

Thank You DB!