Bottom Discrimination and Software Update

[MikeR13]

I updated my tzt2 to version 7 and disconnected my tzt to prepare for my installation of my tzt3. I noticed when I turned my tzt2 back on and turned on bottom discrimination all i get is a blank bar across the bottom with no composition. Anyone else experience this? Running p66. Worked fine when I had the mixed system prior to software update and disconnection of tzt. Might also be worth mentioning the boat was at my dock and not moving. Any ideas?

THanks

 

[Deep Blue]

MikeR13,

Once the new TZT2 V.7.01 Software is installed, you must then reset the unit's internal sounder. Failure to do so will cause a communication error between the new internal sounder software and the updated OS and App software.
You can find how to reset the unit’s internal sounder on page 10-11 here:

https://www.furunousa.com/-/media/sites ... for_v7.pdf

I hope this information helps..?
- Deep Blue

 

[MikeR13]

I did reset it. I still had the transducer plugged in when I did it. Dunno if that’s it

 

[Deep Blue]

MikeR13,

Try to rest the unit's internal sounder again, and then reboot the Display. It should work.

- Deep Blue