Airmar B275LHW on TZT 16X

[Gaspar]

Hello,

My B275LHW transducer is connected to the TZT 16x furuno and was working fineI, on Sunday I went fishing and I noticed that the frequency is no longer Chrip and I only have 50/200 Hz also noticed that the temperature value is always ticking on and off.

What could it be?

 

[TheReaper]

Do you have more than one TZT16X or NAVnet display? If so, ensure that the TZT16X with the transducer connected to it is the one set as the Fish Finder Source in the menu.

 

[Gaspar]

Yes, I only have one TZT 16x and in the transducer configuration menu the model that appears is the correct one B275LHW

 

[TheReaper]

Just double-checked and even though it shows 50 for low and 200 for high...it is chirping. That 50 and 200 at the bottom is normal; it's actually just showing the center frequency. For temperature, ensure that the temp (SST) source in Settings-Initial Setup-Data Sensors-Data Sources is set to TZTXFF.

 

[Gaspar]

The temperature problem has been solved with your recommendation, thank you.

The source for depth must be in the DDF-3D sensor or TZTXFF? At the moment he's with the DDF-3D

The frequencies remain as pictured LF - 53 KHz / HF - 200 KHz

 

[TheReaper]

Use the TZTXFF as source for depth. The frequencies listed "LF- 53 KHz / HF - 200 KHz" are fine...it is chirping with the B275LHW.