Adding new points

[buckshot]

When I add add a point by using the pause/history on my sonar screen it does not seem to be showing on my other TZT2 on the navigation screen. I thought any point you added to one TZT2 would show on every TZT2 in the network.

 

[Johnny Electron]

The the two units running exactly the same version of software?
For the unit that dropped the point; if you flip over to the plotter screen, does the point show up the the plotter page?

 

[buckshot]

Both units have same same software, One unit full screen chartplotter and the other full screen sonar. Everything is in the network also. I would place a new point on the sonar screen and it would not show up on the plotter screen. I cannot seem to figure out why. I changed to split screen the chartplotter to include sonar and then it worked fine. I did not have time to really look into what was going on. I figured I would ask in case I had a simple setting wrong. I will get to the boat and try it again.

 

[Johnny Electron]

Make sure you are meeting the points requirement for the multi-beam, for the mode you are operating.

https://www.furunousa.com/-/media/sites ... n_mode.pdf