Hello,
I recently updated TZT (to 4.12) wirelessly on the boat, and now seem to have a bit of an issue with heading data on TZT?
This is the error message on booting up NavPilot:-
- "Cannont receive heading data. Please check heading sensor. Push any key to continue".
- Start Up Test: - "Heading Sensor: NG".
Can I please get correct settings for data source etc in Network Sensors and Data Source setup screens, given I am running a SC-50, GP-330, NavPilot-711, Pump Accu-Steer, (DFF1-UHD, DRS4D Radar Sensor 24" Radome)? All circa 2012 installation.
Also:-
- is it possible for me to upgrade my NavPilot for Sabiki mode?
- is 4.12 the latest software version for TZT?
- is it typical for the above settings (Data Source, etc) to be modified on TZT software update?
Thanks in anticipation of your reply - any assistance would be greatly appreciated!
Septimus.
I recently updated TZT (to 4.12) wirelessly on the boat, and now seem to have a bit of an issue with heading data on TZT?
This is the error message on booting up NavPilot:-
- "Cannont receive heading data. Please check heading sensor. Push any key to continue".
- Start Up Test: - "Heading Sensor: NG".
Can I please get correct settings for data source etc in Network Sensors and Data Source setup screens, given I am running a SC-50, GP-330, NavPilot-711, Pump Accu-Steer, (DFF1-UHD, DRS4D Radar Sensor 24" Radome)? All circa 2012 installation.
Also:-
- is it possible for me to upgrade my NavPilot for Sabiki mode?
- is 4.12 the latest software version for TZT?
- is it typical for the above settings (Data Source, etc) to be modified on TZT software update?
Thanks in anticipation of your reply - any assistance would be greatly appreciated!
Septimus.