flowmotion
Furuno Fan
For anyone interested:
I just validated a couple of things involving a USB bridge and were the SD card can reside during boot up.
Using a RAM234-HUB1U 6-port usb hub I was able to connect the SDU-001 and MCU-004.
In addition, I found no issues putting the chart sd card in a SDU-001 card slot instead of in the rear slot of the MFD.
Since I plan on flush mounting the touch2 I wanted access to the sd card externally.
I just validated a couple of things involving a USB bridge and were the SD card can reside during boot up.
Using a RAM234-HUB1U 6-port usb hub I was able to connect the SDU-001 and MCU-004.
In addition, I found no issues putting the chart sd card in a SDU-001 card slot instead of in the rear slot of the MFD.
Since I plan on flush mounting the touch2 I wanted access to the sd card externally.