Hammerhands
New member
After installing all new: Processor,Tz12 MFD,control unit, and terminating to the pg 700 heading sensor and all nmea2000 cabled in same order, the control unit does not power up. Also there is no power to the heading sensor for location test. I have checked fuse and power to processor it shows 12.8 volts so thats not it. I fired up the MFD went into index, searched for Pilot to find, Processor not installed as a result there. Is there something I missed with the connections. I was informed i wouldn't need a can bus unless i added another equpiment unit.
Any help i can recieve i'm greatly appreciative of, Thank You
Any help i can recieve i'm greatly appreciative of, Thank You