Happy New Year :jump
I just had installed on my trawler two TZTouch3 units. They replaced one TZTouch2. When my depth sounder, a 525 STID-MSD was connected to the new TZTouch3 it was not reading accurately. But was working perfectly on the TZTouch2.
The installer checked the transducer and said it was working, but did not understand the cause of the wild readings. So far I confirmed the installation and went through the TZT3 manual and tried almost every combination of setting allowed. The system still does not give an accurate reading.
I can tell for sure, since I have another transducer on the network and it reads accurately. I have one transducer on at a time to ensure no interference. Also, if I switch one TZT3 unit to display the 525 transducer the same display occurs.
This is extremely frustrating. Could some one please offer me some suggestions other than replace the 525 transducer.
Thank you for your help.
bill :angry
I just had installed on my trawler two TZTouch3 units. They replaced one TZTouch2. When my depth sounder, a 525 STID-MSD was connected to the new TZTouch3 it was not reading accurately. But was working perfectly on the TZTouch2.
The installer checked the transducer and said it was working, but did not understand the cause of the wild readings. So far I confirmed the installation and went through the TZT3 manual and tried almost every combination of setting allowed. The system still does not give an accurate reading.
I can tell for sure, since I have another transducer on the network and it reads accurately. I have one transducer on at a time to ensure no interference. Also, if I switch one TZT3 unit to display the 525 transducer the same display occurs.
This is extremely frustrating. Could some one please offer me some suggestions other than replace the 525 transducer.
Thank you for your help.
bill :angry