Wiring Nav Pil 700

[BReceski]

I'm trying to make sure I get this wired correctly. I currently have a TZTouch 3, a radar, and a scx wired into a nmea 2000. My plan is to run the rudder reference to the processor, the steering solenoid to the processor, then tieng this all into the nema 2000 backbone. Does the processor need to be wired for power? Does this sound correct? If so, does anyone have any pictures of where the nmea 2000 gets wired into the processor? Any helpful information on this I woukld appreciate. I have had this since last year and still dont have it hooked up.
Thank You for any assistance.

 

[Kraken]

The wiring diagram for the Pilot will be in the back of the installation manual. The processor does need to be connected to power. See attached diagram.

 

[BReceski]

The wiring diagram for the Pilot will be in the back of the installation manual. The processor does need to be connected to power. See attached diagram.

View attachment 6691

 

[BReceski]

Trying to fully understand this. To the processor I will wire power for the processor ,the control unit , and the rudder reference? The other connection to the processor will be my NMEA 2000 backbone. This will connect everything together. My satelite compass and TZTouch 3. Am I understanding this? Sorry for so many questions.
Thanks Again.

 

[Kraken]

Correct. Power gets applied to the processor and then your pump, control head, RRU and NMEA2000 backbone all get connected to the processor.