Hi All,
Plan on upgrading my navigation system. Currently running a GP1971F paired with a B175HW along with an older NavNetVX2 10.4 and 7 inch dual screen connected to a P66.
Looking to scrap the older VX2 system and get a single TZT12F with the DRS4DNXT dome along with a transom mount side scan transducer (225T-TM904).
Ideally, would keep the 1971 connected to the B175HW, and was curious if it were possible to somehow pigtail that transducer to run on the new TZT12F so i could utilize both the transducers on the large screen. Otherwise, concerned about interference between the B175HW and new side scan transducer, is there any way to adjust the frequency range of the 175 to avoid this?
Lots of questions here and appreciate any help you could offer.
Plan on upgrading my navigation system. Currently running a GP1971F paired with a B175HW along with an older NavNetVX2 10.4 and 7 inch dual screen connected to a P66.
Looking to scrap the older VX2 system and get a single TZT12F with the DRS4DNXT dome along with a transom mount side scan transducer (225T-TM904).
Ideally, would keep the 1971 connected to the B175HW, and was curious if it were possible to somehow pigtail that transducer to run on the new TZT12F so i could utilize both the transducers on the large screen. Otherwise, concerned about interference between the B175HW and new side scan transducer, is there any way to adjust the frequency range of the 175 to avoid this?
Lots of questions here and appreciate any help you could offer.