TZT14 with DRS6A Radar

Reel Catch

New member
Furuno Tech Support: I have a TZT14 with a DRS6A/PSU012 connected to it with an ethernet cable via a HUB-101. This setup has worked flawlessly since it's installation in 2016. Just recently I activated the radar by pressing the Radar Tx button on the TZT14 display menu. Then, the Radar function buttons all came up on the TZT14 display but they were all grayed-out and would not respond when pressed. I shut the system down and rebooted.....same thing. Perhaps you can offer some suggestions of what to check before I start to trouble shoot. Thank you. Joe
 
Check to make sure there is a solid Green Power indicator illuminated on the PSU012.
If power is good, if you are using the LAN connections on the PSU012, unplug both and run the RADAR cable LAN connection direct to the HUB101. On the HUB101 you should get a solid amber LED and a flashing green LED on the port you plug the RADAR into also same indication where the TZT14 plugs in.
 
Thanks, Titanic II. I'll be sure to perform the tasks you recommended and report back on this forum for follow-up advise. Joe
 
Back
Top