nema 0183 out put not working

[jimalmond]

just installed a touch 2 system in place of the nn3d unit..everything is working but the output to the yamaha speed gauge ( gps is on in this gauge)and the vhf radio. it is hooked up exactly like the other system and we have turn on and off all the switches in both 2k and 0183 sides of the touch 2 and still cant get either to work.

please advise

jim

 

[Johnny Electron]

If you can't output GPS from NMEA 2000 or NMEA 0183, then you might not have a good GPS fix. The unit can't output what it doesn't have. Please check the stat status screen and ensure you have a good fix with a HDOP of less than 1.9

 

[jimalmond]

johnny

everything else in the system is working fine

the nn3d was out puting the gps signal to the yamaha square gauge and the icom radio for the gps location and neither of these are working hooked up the same way with the tz touch 2

jim

 

[Johnny Electron]

They could be looking for the RMC sentence which the NN3D had as a selection but the TZT2 has yet to add. We have requested it to be added but doubtful if it will be in the next very soon to release v3.01. It should be in the following update.