NavNet VX2 C-MAP problem with NMEA UDP output

[lior246]

Hello
I have the RDP-149 10" with radar 1834C and Furuno AIS transponder 50, and a second plotter 7" in the cockpit. I have two problems.
1. The second unit freezes sometimes. After a reboot of both plotter, it works again properly.
2. I use also my PC for navigation and get the NMEA data over Ethernet from the plotter. after a while the plotter stops sending NMEA data (only the AIS continue). After a reboot, it works again. I have the SW 3.03. Can you help me to solve the problem?

 

[Johnny Electron]

Step one would be to upgrade the NavNet to the current version of software (4.03)

 

[lior246]

Thank you for the replay. I will be on the boat in two month and will update the SW. Do you have any further information if those problems are SW related?

 

[Johnny Electron]

To properly tap into the Furuno network you should have a SDK. The SDK comes with the DLL and the needed technical data. I can't comment beyond that.

 

[lior246]

Dear Johnny, Thanks a lot for your replay. Where can I get the SDK? I am an IT guy and I would be more then thankful if you could help me.

 

[Johnny Electron]

Contact our USA HQ (360-834-9300) and ask for Matt Wood.

 

[lior246]

Hello

I update the sw to 4.03. the GPS sentence get lost every few hours/minutes (UDP post 10021). when I restart the plotter, it comes again. Please, can you advise me what it can be?

Tanks
Lior

 

[Johnny Electron]

SDK like our commercial range of products are not supported on this general user forum. Please contact SDK support with your licence number.