Mirror Waypoints on dual TZT2 displays

[Makai]

I have 2 x 12" TZT2 displays installed on the same ethernet network.
Trying to get a mirror copy of waypoints so when they are created on either unit they will show on both.
Haven't been able to work out a setting for this so hoped someone here would have done it before.

 

[Johnny Electron]

Ensure they are at the same software version. If on the same network, they share waypoints over the network automatically.

 

[Makai]

Ensure they are at the same software version. If on the same network, they share waypoints over the network automatically.

Hi Johnny. They are the same version. Connected via ethernet and nmea2000 with only 1 network of each. Can see DFF3d and DFF1UHD on both units so network seems fine. Last time out I created different marks on both units but neither shared that across to the other TZ unit

 

[Johnny Electron]

Something goofy with the software because the network like you say seems to be working on both units. While the software is the same, make sure it is also the newest version v8.01. If not working, backup your points and routes factory clear them both and then turn the master setting back on. Test the integration of waypoints and ensure it works. If it does, import in your points and test again. It might be that you have some corrupt user data keeping the flow from working or that the units just need a good clean out.

 

[Makai]

OK seems like a reset is the way to go as both versions are 8.01. I do have 1 unit logged into a timezero account. Sync's my waypoints. Could this cause an issue?

 

[Johnny Electron]

No. Sync to TimeZero would be fine. Just make sure if your wifi is ON it is connected to something. If it is just floating looking for sources to connect to, it will eat a ton of CPU time and run slower leading to issues. Staying connected is fine as long as you have a connection. Never leave the wifi ON running if not actively connected to something.