Measure and Mark

[Westbay1]

On my Simrad display I am able to measure and when done mark where I measured to, is this possible on tzt2? On this i measure, the cursor stays where i measured to, then I click mark at cursor.

I seem to be able to measure fine, but am forced to stop measuring and the cursor is not on where I measured to. I use this function alot when wreck fishing to set my anchors for distance and heading, I need to mark 2 spots for the anchors.

Thanks!

 

[C-Bass]

Good afternoon Westbay1,

Thank you for your inquiry. So are you using the measurement tool, it can be found by placing your finger on the right hand side of the display and swipe out towards the center.




Kind Regards,
C-Bass

 

[Westbay1]

Good afternoon Westbay1,

Thank you for your inquiry. So are you using the measurement tool, it can be found by placing your finger on the right hand side of the display and swipe out towards the center.




Kind Regards,
C-Bass

I figured this part out fine, but i want to mark the point i measured to with a way point. What would the next step be?

Thanks