GP1871f x B260B x splicing Extension Cable DST-10F

[Alan]

Good morning everybody!

I have a furuno probe (GP1971f) and a B260B MM transducer, which connects via the extension cable (DST-10F PN 33-594-01)

I need to reconnect the extension cable at the end that connects to the transducer.

The GP 1971F probe has 10 pins.

The transducer has 9 pins.

How do I connect them???

Thank you very much in advance!

 

[Kraken]

Good morning everybody!

I have a furuno probe (GP1971f) and a B260B MM transducer, which connects via the extension cable (DST-10F PN 33-594-01)

I need to reconnect the extension cable at the end that connects to the transducer.

The GP 1971F probe has 10 pins.

The transducer has 9 pins.

How do I connect them???

Thank you very much in advance!

That is an Airmar mix and match transducer. You would need to get a mix & match cable from Airmar to go to the 10 pin connection on the GP1971F

 

[Alan]

That is an Airmar mix and match transducer. You would need to get a mix & match cable from Airmar to go to the 10 pin connection on the GP1971F

This extension cable I have is from Aimar. it is from 10 pins to 9 pins. its splice connection was oxidized and I needed to re-splice the cables. I need to be sure of the graphic pattern of the B260 Aimar transducer.

 

[Johnny Electron]

Airmar Mix and Match transducers are a product sold by a company called GEMECO, not Furuno. They should be contacted for support and I am sure they can provide you any needed drawings or parts.

 

[Alan]

Thank you very much for your attention and patience...
I'll look for their contact...
hug