FLIR Camera

[MikeR13]

Hey Gang, I have a flir m232 camera installed and was running through a decoder currently. I know with the new software update it can now be run on the tzt2 through direct ethernet. Anyone know how to change the IP of the camera so the furuno mfd can recognize it? I have the instructions that furuno has provided however when following them the screens etc looking nothing the same as the ones on my computer.

Thanks

 

[Marlin My Darlin]

Good afternoon,
Are you using the directions below:

https://www.furunousa.com/-/media/s..._flir_camera_setup_procedures_for_ip_type.pdf

If so, please let us know if you are still having issues.

Thank you,

 

[Johnny Electron]

I just setup a FLIR M232 today with v6.23 and it worked wonderful. I tested it with both 6.21 and 6.23 and works like a champ.

 

[MikeR13]

My issues is when i try to get into the FLIR camera pages to adjust the IP i cant access the page like in the instructions. I keep getting an error. I can access The JCU page but not the camera itself.

 

[Johnny Electron]

You might need newer firmware in the FLIR or it has a problem that needs to be addressed.